Today we tackled the DIY project of our card box. I had purchased 3 patterned hat boxes from Hobby Lobby many, many months ago with this project in mind. I love the look of a faux wedding cake when all the boxes are stacked!
So a few hours later, our card box is finished! We could not be happier with the end result.
Here is what we did...
We took off the lids and turned the boxes upside down. Chris measured and cut a hole in the bottom of the box that was the same measurement of the box to be placed on top of it.
Here is a shot of all three boxes stacked. Since they all fit so snug, there was no need for ANY adhesive. To seal the opening at the bottom, we placed the lid to that box back on.
Here all three boxes are stacked and ready for decoration!
Around the base of each box, I applied ATG tape.
After the ATG tape, black ribbon was applied.
To add a little something extra, I created bows from a thicker black ribbon and used a little hot glue to hold them in place. That is it! I am not sure if it needs something extra...so.....
I placed faux anemone flowers on the bows. These are not permanent until I see what you think....should the flowers stay? Should I add some bling? What do you think?